Punjab 10th Class Math Chapter 7 Introduction to Trigonometry Mcqs Test Online
Questions 10
Total Marks 20
Time 10 Mins

Punjab 10th Class Math Chapter 7 Introduction to Trigonometry Mcqs Test Online

Start your preparation for Punjab 10th Class Math Chapter 7 Introduction to Trigonometry Mcqs Test Online. This online test contains 10 MCQs and you have 10 Minutes to complete it. The total marks for this test are 20. This test is valid for students of All Punjab Boards (Lahore, Gujranwala, Multan, etc.) following the PCTB Syllabus. Read the questions carefully and select the correct option below to see your result.

Math Chapter 7 Introduction to Trigonometry Mcqs Test Online for All Punjab Boards 10th Class

 0%

Question 1 of 10

Math

1. 20” =
1.
2.
3.
4.

Question 1 of 10

Question 2 of 10

2. sec 2 θ =
1.
2.
3.
4.

Question 2 of 10

Question 3 of 10

3. 1/2 cosec 45°
1.
2.
3.
4.

Question 3 of 10

Question 4 of 10

4. 3π/4 radians =
1.
2.
3.
4.

Question 4 of 10

Question 5 of 10

5. The union of two non-collinear rays, which have common end point is called
1.
2.
3.
4.

Question 5 of 10

Question 6 of 10

6. The system of measurement in which the angle is measured in radians is called
1.
2.
3.
4.

Question 6 of 10

Question 7 of 10

7. 1/1+sinθ + 1/1–sinθ
1.
2.
3.
4.

Question 7 of 10

Question 8 of 10

8. cosec²θ – cot²θ =

1.
2.
3.
4.

Question 8 of 10

Question 9 of 10

9. Sec θ cot θ =
1.
2.
3.
4.

Question 9 of 10

Question 10 of 10

10. If tan θ = √3, then θ is equal to
1.
2.
3.
4.

Question 10 of 10


 

Guide for Punjab Board Students

Students of BISE Lahore, Gujranwala, Multan, and other Punjab boards must follow the SLO based pattern.

Top Scoring Tips for Punjab:

  • Textbook Reading: The paper is 100% derived from PCTB books. Do not rely only on keybooks.
  • Objective Paper (20%): Practice these online MCQs repeatedly as they are taken from 5-Year Past Papers.
  • Bubble Sheet: Ensure you know how to fill the OMR sheet correctly.

Test By Class
Test By Subject

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button